Guidelines for Configuring Games with the Aztech Sound Card.

16AZCARD

The following document describes how to configure MS-DOS based games with the 16AZCARD sound cards in Windows 95. This document assumes that you have already loaded the real mode drivers for the sound card and the card functions properly in Windows 95. The drivers for these cards can be found on the driver diskette that was shipped with the sound card. The part number of the disk is 16AZCARDDSKX and the most recent version of the driver is 1.41.

Finding the Your Sound Cards Settings

Many games require that you know the hardware settings of your sound card in order to install the game. To find the settings of your 16AZCARD perform the following procedure:

  1. Click Start, then Run.
  2. Type: sysedit and click OK
  3. The System Configuration Editor will open up. We want to look in the AUTOEXEC.BAT file. Do not make any changes to this file.
  4. There will be a SET BLASTER=...... line. This stores some of the settings for your card.
    • A= Base I/O port address of the card (soundblaster).
    • I= Interrupt Request Level (IRQ) of the card.
    • D= Low (8-bit)DMA channel of the card.
    • T= Card type - not used by game install programs.
  5. There will be a SET GALAXY=...... line. This line stores the rest of the settings for the card.
    • A= Base I/O port address of the card (soundblaster).
    • I= Interrupt Request Level (IRQ) of the card.
    • D= DMA channel of the card.
    • K= CODEC IRQ - probably not used by any game install programs.
    • P= Midi Port address.
    • T= High (16-bit) DMA channel .
  6. Close the System Configuration Editor.

Installing the Program

Once you have found the settings of the card it is time to run the installation program for your game. This can be done from the Add New Programs wizard, located in the Control Panel, if the installation program is in the root directory of the diskette or CD-ROM from which you are installing. Once you have located the install program, click on the Finish button to start the installation program.

During the course of the installation program you may be asked questions about the hardware in your system. You will have all of the settings you need from the procedure above. If you are asked what type of sound card you have and Aztech is not a choice, try either Adlib or SoundBlaster Compatibles.

Running the Program

After you have finished installing the program, run the program:

  1. Right Click on the My Computer icon. Then choose Explore.
  2. Double click on the drive letter to which the application was installed.
  3. Then double click on the directory to which it was installed.
  4. Find the executable file (to do so, click view, then details) and look for the word application on the right side.
  5. Double click the icon.

    If the program runs correctly, you do not need to perform the steps listed below. Instead, go to the end of this document where icons and shortcuts are discussed. If the program is not functioning properly, you may need to modify the MS-DOS Mode configuration to make the game work. Follow the steps below:

  6. Right Click on the My Computer icon. Then choose Explore.
  7. Double click on the drive letter the application was installed to and then double click on the directory.
  8. Find the executable, (click view, then details) and look for the word application on the right side of the screen, right click then choose Properties.
  9. Choose the Program tab and then click on the Advanced button.
  10. Click on MS-DOS mode and then Specify a new MS-DOS configuration and add the following lines:

    CONFIG.SYS

    dos=high,umb
    device=c:\windows\himem.sys
    Note: The next line is needed if your game requires EMS
    device=c:\windows\emm386.exe ram 2048
    Note: The next line is used for games that do not need EMS
    device=c:\windows\emm386.exe noems
    Note: The next line can be copied from your config.dos file. This line will vary depending upon the CD-ROM drive you are using - our example shows an NEC dual speed
    device=c:\cdrom\nec_ide.sys /d:mscd001 /v
    Note: The line listed below must be present if Plug-n-Play cards are installed, otherwise it is not needed.
    devicehigh=c:\plugplay\drivers\dos\dwcfgmg.sys

    AUTOEXEC.BAT

    C:\G2KAUDIO\UTILITY\GWBVOL /AUX1:16,16 /AUX2:16,16 /MC:E
    SET BLASTER=A220 I5 D1 T4
    SET GALAXY=A220 I5 D1 K2 P534 T6
    SET SOUND=C:\G2KAUDIO
    c:\windows\command\mscdex.exe /d:mscd001 /m:10
    prompt$p$g
    path c:\windows;c:\windows\command;c:\dos
    set temp=c:\dos

  11. Click on the OK button. On the Properties screen, click on OK.
  12. An icon will be created, double click the icon to start the game.

Icons & Shortcuts

The MS-DOS icon created above, can be moved to the desktop or a folder, for the customerís convenience. Simply drag and drop the icon to itís new location with the mouse. You can make a copy of the icon by holding down the Control key as you drag the icon to a different location. You can also drag the icon from the desktop to the Start button and drop it. A shortcut will be created for you on the Start Menu.

Other material can be found in the following documents
How to enable MS-DOS support for IDE CD-ROMS
How do I add items to the Start Menu?

The information in these articles is provided "as-is" without warranty of any kind, and all warranties are hereby disclaimed, whether express or implied, including, without limitation, the implied warranties of merchantability, fitness for a particular purpose and non-infringement. Gateway 2000 will not be liable for any damages whatsoever, whether direct, special, indirect, incidental, or consequential (including, without limitation, damages for loss of business profits, business interruption, loss of business information, or any other pecuniary loss) arising out of, or related to your use of, or inability to use the information in any such article, even if advised of the possibility of such damages. Because some states and jurisdictions do not allow the exclusion or limitation of liability for consequential or incidental damages, the above limitation may not apply to you. You may not further distribute, reproduce, rent, sell, transfer or license these articles.

If our documentation hasn't helped you,
this might be a good time to send
an e-mail to Technical Support.

[Products] [Global Site] [Tech Support] [Corporate Information] [The Cow Zone] [What's New] [Glossary] [Search] [Home]

[Gateway 2000]
Copyright © 1996 Gateway 2000 Inc. All rights reserved.
Please see our Legal Information. Please send feedback to Webmaster Central.