1 This device requires a driver from the \DRVLIB directory on the
2 Windows NT CD-ROM, or the Windows NT Driver Library.
3 This device requires a driver from the Windows NT driver Library.
4 See the following section on accessing these drivers.
5 System requires ALR EISA Config utility 2.13 or later to enable
6 COM ports in Windows NT 3.5.
7 External Cache must be disabled to run Windows NT 3.5
8 Requires AST BIOS Rev. 1.02 to install and run Windows NT 3.5.
9 Requires AST BIOS Rev. 2.03 to install and run Windows NT 3.5.
10 Must copy ABIOS.SYS and *.BIO from reference diskette to root
11 directory of boot drive to install Windows NT on this system.
12 Onboard S3 not supported on this model.
13 Requires the IBM RAID Controller v2.0 driver located in Windows NT
14 Driver Library.
15 This system only supports 640x480x16 video resolution.
16 Contact Panasonic at 1-800-LAPTOP5 for CD-ROM compatibility with
17 Windows NT 3.5.
18 To Install Windows NT 3.5 on this system SCSI detection must be
19 skipped during setup.
20 Refer to setup.txt to properly configure this system for printing
21 in Windows NT 3.5.
22 Refer to SETUP.TXT on the Windows NT 3.5 CDROM for information on
23 configuring this machine/device before installation.
24 Requires AMD Bios Revision 0.02.18 to function as a multiprocessor
25 system.
26 Contact the manufacturer for information on running Windows NT on
27 this machine.
28 This system requires Windows Sound System driver to enable sound.
29 Supported on x86 only.
30 For best performance, this adapter should be configured to IRQ-11.
31 Tape drives are not supported with this adapter.
32 Tested with firmware revisions 3.10 and 3.20.
33 This adapter requires an active terminator for proper performance.
34 The floppy controller on this adapter is not supported.
35 This adapter must be configured for 5 MB/second asynchronous I/O
36 to work with listed CD-ROM drives from NEC.
37 This adapter must be configured for 5 MB/second asynchronous I/O
38 to work with listed CD-ROM drives from Chinon, Hitachi, and NEC.
39 Tested with the Unisys PW2 Advantage 3256 (Flemington).
40 AIC-7770c and AIC-7770e are supported.
41 Tested with the Unisys PW2 Advantage Plus MPE 4668.
42 Removable media drives are not supported with cache enabled.
43 Tested with Compaq Deskpro XL 466 and HP Vectra XU 5/90c.
44 Scanners are not supported with this adapter.
45 Tested with firmware rev. 005E.
46 Tape drives are not supported with this adapter.
47 Tested with firmware rev. 007A.
48 To use this adapter, at least one device on the bus must provide
49 termination power.
50 Refer to SETUP.TXT for information on configuring this adapter.
51 Removable media is not supported with this adapter.
52 SCSI BIOS dated before 1991 requires PS/2 Reference Diskette
53 version 1.12 or later.
54 This adapter cannot be used for CD Setup. To install Windows NT
55 with this adapter, use the WINNT.EXE Setup method.
56 The driver for this adapter defaults to IRQ-15.
57 Tested with NEC RISCstation 2000
58 Tested with Dell Omniplex 560.
59 Tested with Digital Equipment Corp. AlphaServer 2100 4/200
60 (Digital Equipment Corp. 2100 Server model A500MP).
61 Tested with COMPAQ Portable 486c.
62 Tested with NCR System 3000 Model 3360.
63 This driver is not supported on Multi-Processor computers.
64 This adapter is only supported on IRQ-5.
65 Tested with firmware revision 005.
66 Requires firmware revision 008.
67 This drive is not supported for use with the Future Domain
68 TMC-850M and TMC-1670 adapters.
69 This drive requires double-termination when used with the Adaptec
70 AHA-1742A.
71 Users may encounter problems with CD-R (recordable) discs.
72 Requires firmware version 2.5 for proper operation, please contact
73 NEC Technical support (800-388-8888) for assistance.
74 This drive is not supported for use with the Adaptec AHA-1740 and
75 AHA-1742 adapters.
76 This drive is not supported on the Alpha platform.
77 Requires firmware revision 1.10C to function properly with Windows
78 NT.
79 Supported with CD-ROM drives based on Panasonic CR-52x and CR-56x
80 models only.
81 After installing the driver for this CDROM drive from the Setup
82 Application please Shut-down Windows NT and power cycle your machine.
83 After completing installation of Windows NT with the driver for
84 this CDROM drive installed, please Shut-down Windows NT and power cycle
85 your machine.
86 Requires Service-Pack 2 for proper performance.
87 This drive is not supported with the Adaptec AHA-1640 adapter.
88 NTBackup does not support autoloaders. This drive is supported in
89 single-tape operation only.
90 Requires firmware version 484 or later for proper operation.
91 This drive is not supported with the Future Domain TMC-850M(ER).
92 Tested with firmware rev. ARCHIVE IBM4326NP/RP !D04AP
93 This drive is not supported with the IBM PS/2 Microchannel SCSI
94 Host Adapter (with cache).
95 This drive is not supported with the Adaptec AHA-1510 adapter.
96 The Future Domain TMC-1670 with bios version 3.0 requires that the
97 bios be disabled when used with this drive.
98 Compression jumper must be in enabled position on this drive.
99 This drive is not supported with the UltraStor 24fa adapter.
100 Requires firmware rev. DEC9314
101 Tested with firmware rev. DEC4318
102 Tested with firmware rev. DEC930A
103 Tested with firmware rev. DEC9514
104 This drive is not supported with the Adaptec AHA-1742A adapter.
105 For use with floppy controllers. Separate interface controllers
106 for these types of drives are not supported.
107 The Adaptec emulation mode on the Dell Drive Array(DDA) must be
108 disabled for compatibility with the hardware's Windows NT Driver.
109 This adapter is currently supported in its ESC-1/ESC-2
110 compatibility mode only.
111 Not supported with the Future Domain 1670 SCSI Adapter.
112 Tested with BusLogic BT-747S.
113 Not supported as boot device.
114 Not supported with the Future Domain TMC-850m.
115 Tested with firmware revision HQ30.
116 Requires firmware version 1.15.15s for proper performance.
117 Versions of this board based on the 688LX or 68003 chip require
118 more than 1mb of video memory to support 800x600x65k.
119 Some revisions of this board are not supported under Windows NT.
120 Please see the Release Notes on how to identify these boards.
121 The AVGA will occasionally present "snow" on the screen at
122 800x600.
123 Requires Rev E. Bios 3.09 for proper performance.
124 Tested with NCR System 3000 Model 3445.
125 Tested with NCR System 3000 Model 3350.
126 Random pixel corruption may occur on Pentium based systems.
127 65k colors are supported with a 565 DAC, 32k colors with a 555
128 DAC.
129 S3 based adapters that use the ICS DAC will not function with the
130 S3 driver. The Standard VGA driver must be installed during setup for the
131 system to function properly.
132 Some older 928 chips do not support 800x600xTRUE with 2Mb of RAM.
133 Not all video board/monitor combinations are able to properly
134 display 1600x1200.
135 Some video boards based on Western Digital chips have experienced
136 misplaced pixels when running in Pentium based computers.
137 ATI Mach 32 based boards with rev. 003 of the Mach 32 chip will
138 not support 800x600 with only 1Mb of RAM.
139 2MB Video Memory only supported on Cirrus 543x series of chips.
140 This adapter has been verified to work with Network Monitor
141 FDDI tested only.
142 Not supported with Multiprocessor MIPS systems.
143 Not compatible with IBM Thinkpad 700 or Thinkpad 720.
144 Non-bidirectional parallel port machines may suffer performance
145 degradation when the driver for this adapter is installed.
146 The Toshiba 4700CS and 4800CT are not supported in Bi-directional
147 mode with this adapter.
148 Not supported in Sound Blaster 1.x compatibility mode.
149 Supported in Sound Blaster 1.x compatibility mode.
150 Error control and flow control forced on.
151 Advanced features disabled.
152 Supported as a client modem only.
153 Flow control forced on.
154 Maximum DTE speed set to 2400.
155 Maximum DTE speed set to 9600.
156 Modem compression forced on.
157 Tested as standard serial ports only.
158 Does not support SPACE or MARKET Parity or 1.5 stop bit.
159 Shared interrupt configuration is not recommended when running RAS, use one interrupt for each port.
160 Supported on x86 only.
161 If this model was purchased prior to March 1993, contact Data Storage Marketing for compatibility
verification.
162 To install Windows NT 3.1 on this system, TMV1.sys on the Windows NT Setup disk 1 must be renamed or removed.
163 Windows NT does not currently support Advanced Power Management (APM).
164 This system requires an ABIOS.SYS driver dated after 11/1/93 to support IDE drives. Call Microsoft Product Support
Services to obtain
165 this update.
166 To run Windows NT 3.1 on this system contact the IBM HelpCenter at 1-800-772-2227.
167 Patch required for the IBM Thinkpad 750 series to install Windows NT 3.1. Available on
CompuServe in the WINNT forum in library 2 and also in the same locations as the Windows NT Driver
Library.
168 IDE drives greater than 500MB are only supported with BIOS Version 1.23 or later, with BIOS setting for IDE in
standard mode.