Trantor T130B

This is the Trantor T130B SCSI adapter shown. Listed below are the possible Interrupt Request Line (IRQ), Base I/O Address, Base Memory Address, and other jumper/switch configurations:

	

Setup Choice for Windows NT 3.5
Trantor T130b

Type of External SCSI Connector
25-Pin "Normal"

Note1: - This adapter is only supported on IRQ-5.

Note2: - To use this adapter, at least one device on the bus must provide termination power.


I/O
ADDRESS	SW1	SW2
350H		OFF	OFF
340H		OFF	ON
250H		ON	OFF
240H		ON	ON

BIOS ROM
ADDRESS		SW3	SW4	SW5
Disabled	OFF	OFF	OFF
CA000H		OFF	OFF	ON
CE000H		OFF	ON	OFF
DA000H		OFF	ON	ON
DE000H		ON	OFF	OFF
Reserved	ON	OFF	ON
Reserved	ON	ON	OFF
Reserved	ON	ON	ON

BOOT ROM	SW6
Enable		OFF
Disable		ON

SW7	Reserved (Should be OFF)
SW8	Reserved (Should be OFF)

JUMPER BLOCKS


ZERO
WAIT STATE	JP2
Enable		ON
Disable		OFF

JP3
IRQ	PINS 1-2	PINS 3-4	PINS 5-6
NONE	OFF		OFF		OFF
3	ON		OFF		OFF
5	OFF		ON		OFF
7	OFF		OFF		ON

Note - Jumper block jp4 is used for the led activity light on the hard disk

Zurück zur Übersicht