Trantor T128

This is the Trantor T128 SCSI adapter shown. Listed below are the possible Interrupt Request Line (IRQ), Base I/O Address, Base Memory Address, and other jumper/switch configurations:

	

Setup Choice for Windows NT 3.5
Trantor T128

Type of External SCSI Connector
25-Pin "Normal"

Note1: - To use this adapter, at least one device on the bus must provide termination power.

Note2: - Refer to SETUP.TXT for information on configuring this adapter.

Note3: - This adapter is only supported on IRQ-5.


SW1	Reserved
SW2	Reserved
SW3	Reserved
SW4	Reserved

BOOT ROM	SW5
Enable		ON
Disable		OFF

ZERO
WAIT STATE	SW6
Enable		ON
Disable		OFF
		
MEMORY
ADDRESS	SW7	SW8
CC00H	OFF	OFF
C800H	OFF	ON
DC00H	ON	OFF
D800H	ON	ON

JUMPER BLOCK JP1

IRQ	PINS 1 & 3	PINS 2 & 4	PINS 3 & 5

3	OFF		ON		OFF
5	ON		OFF		OFF
7	OFF		OFF		ON

Zurück zur Übersicht