http://www.wi-inf.uni-essen.de/~schwarze/nt/karten/scsi3.html (Einblicke ins Internet, 10/1995)
Adaptec 1540B/1542B
Adaptec 1540B/1542B
This is the Adaptec 1540B/1542B SCSI adapter shown. Listed below are the possible Interrupt Request Line (IRQ), Base I/O Address, Base Memory Address, and other jumper/switch configurations:
Setup Choice for Windows NT 3.5
Adaptec 154x
Type of External SCSI Connector
Low Density Shielded
Note: The 1540B and the 1542B were tested with firmware revisions 3.10 and 3.20.
J5 - GENERAL CONTROLS
PIN 1 SYNCHRONOUS TRANSFER NEGOTIATION ENABLE/DISABLE
PIN 2 DIAGNOSTICS (USED ONLY AT ADAPTEC)
PIN 3 SCSI PARITY ENABLE/DISABLE
SCSI
I.D. PIN 4 PIN 5 PIN 6
0 ON ON ON
1 OFF ON ON
2 ON OFF ON
3 OFF OFF ON
4 ON ON OFF
5 OFF ON OFF
6 ON OFF OFF
7 OFF OFF OFF
DMA
CHANNEL PIN 7 PIN 8
0 ON ON
5 OFF ON
6 ON OFF
7 OFF OFF
IRQ PIN 9 PIN 10 PIN 11
9 OFF OFF OFF
10 ON OFF OFF
11 OFF ON OFF
12 ON ON OFF
14 OFF OFF ON
15 ON OFF ON
DMA
SPEED PIN 12 PIN 13
5 OFF OFF
5.7 ON OFF
6.7 OFF ON
8 ON ON
J6 - BIOS/AUTO SENSE CONTROL
PIN 1 BIOS ENABLE
PIN 2 NOT USED
PIN 3 NOT USED
PIN 4 NOT USED
PIN 5 AUTO SENSE DISABLE
J7 - ADDRESS SELECTION
PIN 1 FLOPPY SECONDARY ADDRESS SELECT (1542B ONLY)
I/O
ADDRESS PIN 2 PIN 3 PIN 4
130h ON OFF ON
134h OFF OFF ON
230h ON ON OFF
234h OFF ON OFF
330h ON OFF OFF
334h OFF OFF OFF
BIOS WAIT
STATE SELECT PIN 5 PIN 6
0 OFF OFF
100 ON OFF
200 OFF ON
300 ON ON
BIOS
BASE ADDRESS PIN 7 PIN 8
DC000 OFF OFF
CC000 ON OFF
D8000 OFF ON
C8000 ON ON
J8 - FLOPPY DISK SELECTION (AHA-1542B ONLY)
Note - On 1542BS100 series, if the floppy enable is removed, remove all jumpers from J8.
PIN 1 FLOPPY ENABLE
PIN 2 DMA REQUEST 2
PIN 3 DMA REQUEST 3
PIN 4 DMA ACK 2
PIN 5 DMA ACK 3
PIN 6 INT REQUEST 6
PIN 7 INT REQUEST 10
PIN 8 DUAL SPEED ENABLE
J9 - DMA/INTERRUPT SELECTION
PIN 1 DMA REQUEST 0
PIN 2 DMA REQUEST 5
PIN 3 DMA REQUEST 6
PIN 4 DMA REQUEST 7
PIN 5 DMA ACK 0
PIN 6 DMA ACK 5
PIN 7 DMA ACK 6
PIN 8 DMA ACK 7
PIN 9 INT REQUEST 9
PIN 10 INT REQUEST 10
PIN 11 INT REQUEST 11
PIN 12 INT REQUEST 12
PIN 13 INT REQUEST 14
PIN 14 INT REQUEST 15
Zurück zur Übersicht