DPT PM2012

This is the DPT PM2012 SCSI adapter shown. Listed below are the possible Interrupt Request Line (IRQ), Base I/O Address, Base Memory Address, and other jumper/switch configurations:

	

Setup Choice for Windows NT 3.5
DPT PM201x

Type of External SCSI Connector
Low Density Shielded

Note1: - Removable media drives are not supported with cache module installed.

SWITCH BAY 1

SW1
Busy

SW2
Computer bus transfer to controller


SW3
Computer bus transfer from controller

SW4
Cache hit

SW5
Disk read-ahead active

SW6
Disk read

SW7
Disk write

SW8
Controller reset

SW9
Controller interrupt pending to computer

SW10
DAQ asserted to computer

JUMPERS

W7
DPT ROM ENABLE/DISABLE

DPT ROM
ADDRESS	        W19
C8000		OFF
D8000		ON

The remaining settings for this SCSI interface card can be configured using the software supplied by the manufacturer.  
Please consult the documentation that came with your SCSI interface card or contact the manufacturer of the SCSI interface card for 
further information.

Zurück zur Übersicht