DPT PM2011

This is the DPT PM2011 SCSI adapter shown. Listed below are the possible Interrupt Request Line (IRQ), Base I/O Address, Base Memory Address, and other jumper/switch configurations:

	

Setup Choice for Windows NT 3.5
DPT PM201x

Type of External SCSI Connector
Low Density Shielded

Note1: - Removable media drives are not supported with cache module installed.

Jumpers

Floppy Drive	Y20

Enable	OFF
Disable	ON


Floppy
Address	Y34

3F0h	OFF
370h	ON


Optional
ROM Address	Y36	Y37
C8000h	        ON	ON
D8000h   	ON	OFF
DC000h   	OFF	ON
Disabled	OFF	OFF

SCSI
ID	Y25	Y18	Y26
7	ON	ON	ON
6	OFF	ON	ON
5	ON	OFF	ON
4	OFF	OFF	ON
3	ON	ON	OFF
2	OFF	ON	OFF
1	ON	OFF	OFF
0	OFF	OFF	OFF

MEMCS16

(ISA Memory)	Y21	Y28	Memory

Ignore MEMCS16	OFF	ON	16-bit
Decode MEMCS16	ON	OFF	8 or 16-bit


Address Lines Used	        Y19

SA17-19 & LA17-19 driven	ON
Only LA17-19 driven	        OFF


DMA Speed	Y27
4 MB/Sec	ON
5 MB/Sec	OFF

Bus Mastering	Y24
Enabled	        OFF
Disabled	ON

EPROM Size
(Jumper Y23)	Post 1	Post 2	Post 3

256K	        OFF	ON	ON
512K	        ON	ON	OFF

Zurück zur Übersicht