DEC Etherworks Turbo/TP

This is the DEC Etherworks Turbo/TP Network Adapter card shown. Listed below are the possible Interrupt Request Line (IRQ), Base I/O Address, and Base Memory Address jumper/switch configurations:

	

Setup Choice for Windows NT 3.5

Note1: - A DEC EtherWORKS Turbo /TP network adapter might use conflicting memory addresses,
         for example addresses might conflict with Adaptec or Future Domain SCSI adapters. 
         This requires re-configuring the hardware by changing jumpers.


Interrupt Request Line (IRQ)
	S8	S9	S10	S11	S12
IRQ5	ON	OFF	OFF	OFF	OFF
IRQ9	OFF	ON	OFF	OFF	OFF
IRQ10	OFF	OFF	ON	OFF	OFF
IRQ11	OFF	OFF	OFF	ON	OFF
IRQ15	OFF	OFF	OFF	OFF	ON

Base I/O Address
	S5
200h	OFF
300h	ON

Base Memory Address - 64K BUFFER
	S1	S2	S3	S4
C000h	ON	ON	ON	ON
D000h	ON	OFF	ON	ON
E000h	OFF	ON	ON	ON

Base Memory Address - 32K BUFFER
	S1	S2	S3	S4
C800h	ON	ON	OFF	OFF
D800h	ON	OFF	OFF	OFF
E800h	OFF	ON	OFF	OFF

AUI/TP Jumper
	1	2	3
AUI	ON	ON	OFF
TP	OFF	ON	ON

Note - 1, 2, and 3 represent rows of pins that the block jumper fits on (only two of the rows at a time).

Cabling for this Adapter

	Thick Ethernet via AUI Connector
	Unshielded Twisted Pair via RJ-45 Connector

Zurück zur Übersicht