How to Install the TelePath II Modem in Windows 95

After Windows 95 has been installed there are two ways to setup the TelePath II (Gateway part numbers: FAXMODEMR, MODISA001AAUS, & MODISA001ABUS). Perform one of the following sets of instructions to install the TelePath:



  • Go to Control Panel and open the Modems icon. If there are no modems installed, the Add New Modem wizard automatically begins. If a modem has already been installed, click on the Add button to start the Add New Modem wizard.
  • Click the Next button to begin the detection process. The detection should take approximately 30 seconds.
  • Once Windows 95 has detected the modem, click the Next button.
  • Click the Finish button to complete installation.


  • Go to Control Panel and open the Modems icon. If there are no modems currently installed, the Add New Modem wizard will automatically start. If a modem has already been installed Click on the Add button to start the Add New Modem wizard.
  • Place a check in the box next to Don't detect my modem; I will select it from a list and then click the Next button.
  • Select Gateway 2000 from the list of Manufacturers. After Gateway 2000 is selected, scroll down the list of models to the Gateway 2000 TelePath II,14400 Internal and then select it from the list.
  • Click the Next button.
  • You will now be prompted to select the port to use with this modem. Select the Communications port in which the modem is installed and then click the Next button.
  • Click the Finish button to complete the installation.


Hardware:

The following firmware versions were detected as "Gateway 2000 TelePath II 14400 Internal."
SUPERVISOR DATE 12/15/93 REV 4.1
DSP DATE 6/1/93 REV 10
SUPERVISOR DATE 6/24/93 REV 4.1
DSP DATE 6/1/93 REV 10
SUPERVISOR DATE 4/21/94 REV 4.1
DSP DATE 4/20/94 REV 10
SUPERVISOR DATE 11/03/94 REV 4.1
DSP DATE 10/19/94 REV 10
SUPERVISOR DATE 11/16/93 REV 4.1
DSP DATE 11/15/93 REV 10

The following firmware version of the FAXMODEMR were detected as "Sportster 14400 Fax."
SUPERVISOR DATE 2/18/94 REV 4.1
DSP DATE 2/17/94 REV 10



The information in these articles is provided "as-is" without warranty of any kind, and all warranties are hereby disclaimed, whether express or implied, including, without limitation, the implied warranties of merchantability, fitness for a particular purpose and non-infringement. Gateway 2000 will not be liable for any damages whatsoever, whether direct, special, indirect, incidental, or consequential (including, without limitation, damages for loss of business profits, business interruption, loss of business information, or any other pecuniary loss) arising out of, or related to your use of, or inability to use the information in any such article, even if advised of the possibility of such damages. Because some states and jurisdictions do not allow the exclusion or limitation of liability for consequential or incidental damages, the above limitation may not apply to you. You may not further distribute, reproduce, rent, sell, transfer or license these articles.

If our documentation hasn't helped you,
this might be a good time to send
an e-mail to Technical Support.

[Products] [Global Site] [Tech Support] [Corporate Information] [The Cow Zone] [What's New] [Glossary] [Search] [Home]

[Gateway 2000]
Copyright © 1996 Gateway 2000 Inc. All rights reserved.
Please see our Legal Information. Please send feedback to Webmaster Central.