28.8 bps PCMCIA fax/modem

28.8 PCMCIA
FAX/MODEM

FEATURES

ITU-T V.34, ITU-T V.32bis, ITU-T V.32, ITU-T V.22bis, ITU-T V.22, ITU-T V.21, ITU-T V.17, ITU-T V.29, ITU-T V.27ter

Bell 212A and 103 data modes

Supports true hot swapping

Recognizes carrier, dial tone, busy signal

14,400bps data and send and receive fax

FCC Class B and part 68, UL, CSA, DOC certifications

Supports extended AT command set and S-registers

Supports touch-tone and pulse dialing

Ringer equivalence: 0.8B US

Telephone cable included

SPECIFICATIONS

Specifications are subject to change without notice or obligation.

PCMCIA compliance		PCMCIA 2.10 compliant
Commands		Enhanced AT (Hayes compatible TIA/EIA 602) command set
Data communications		ITU-T V.34 (28,800 bps, 26,400 bps, 24,000 bps, 21,600 bps, 19,200 bps, 16,800 bps, 14,400 bps, 12,000 bps, 9,600 bps, 7,200 bps, and 4,800 bps); ITU-T V.32bis (14,400 bps, 12,000 bps, 9,600 bps, 7,200 bps, and 4,800 bps); ITU-T V.32 (9,600 bps and 4,800 bps); ITU-T V.22bis (2,400 bps); ITU-T V.22 (1,200 bps); Bell 212A (1,200 bps); Bell 103J (300 bps); ITU-T V.23 (1,200 bps); ITU-T V.21 (300 bps).
Fax compatibility		ITU-T Group III fax; TIA/EIA 578 Class I and Class 2 fax; ITU-T V.17; ITU-T V.29; ITU-T V.27ter
Power consumption		operating, 950 mW; standby, 475 mW; sleep, 20 mW
Operating modes		Manual dialing and answering DTE-controlled dialing and answering with AT command set Auto answer
Asynchronous data rates		28800, 26400, 24000, 21600, 19200, 16800, 14400, 12000, 9600, 7200, 4800, 2400, 1200, 300 bps
Dialing capability		Touch tone and rotary pulse
Pulse dialing rate		10 pulses/second
Make-to-break ratio		39/61% (US), 33/67% (UK/Hong Kong)
Receive sensitivity		-45 dBm
Tones detected		All North American and most European telephone networks: dial, busy, ringback, modem Note: Incompatible tones include blind dialing based on timeout periods
Line requirements		Public-switched telephone network, including international connections
Diagnostics		Local analog loopback, local digital loopback, remote digital loopback, local interface loopback

The information in this document has been carefully checked and is believed to be accurate. However, Gateway 2000 assumes no responsibility for any inaccuracies that may be contained in this document. In no event will Gateway 2000 be liable for direct, indirect, special, incidental, or consequential damages resulting from any defect or omission, even if advised of the possibility of such damage.