This document contains installation instructions for the STB ET6000 video card drivers. These drivers only need to be installed if the hard drive is formatted, the drivers become corrupt, or the directory is inadvertently deleted. How to install the STB ET6000 Video Card Drivers
Installation instructions
The information in these articles is provided "as-is" without warranty of any kind, and all warranties are hereby disclaimed, whether express or implied, including, without limitation, the implied warranties of merchantability, fitness for a particular purpose and non-infringement. Gateway 2000 will not be liable for any damages whatsoever, whether direct, special, indirect, incidental, or consequential (including, without limitation, damages for loss of business profits, business interruption, loss of business information, or any other pecuniary loss) arising out of, or related to your use of, or inability to use the information in any such article, even if advised of the possibility of such damages. Because some states and jurisdictions do not allow the exclusion or limitation of liability for consequential or incidental damages, the above limitation may not apply to you. You may not further distribute, reproduce, rent, sell, transfer or license these articles.
- Insert the STBET6000 Windows Drivers disk 1 into the floppy drive. From the Program Manager, click the word File in the upper left hand corner, then click the word Run that appears on the menu. In the Command Line box, type:
and click the OK button. The Lightspeed 128 Installation window appears informing you the STB Vision will be installed in the Windows directory. Click the OK button to continue.
a:\setup
- When prompted, insert the STB ET6000 Windows drivers diskette 2 into the floppy drive and click the Continue button. The STB Vision Installation Utility asks if a Program Manager group called STB Vision may be created. Click the Yes button to create this group.
- The STB Vision Installation Utility starts the STB Vision Control Panel for selection of the monitor and the initial display setting. Click the OK button to accept the default settings and proceed.
- The STB Vision Monitor Options window appears. Click the down arrow under the Monitor Selection box to display the possible monitor choices. Click the monitor selection that matches the monitor attached to the computer. Click the OK button to continue.
- From the STB Vision Control Panel, select the Resolution, Virtual Desktop Size and number of Colors. Once all these selections are made, click the OK button to continue.
- The final screen prompts you to restart Windows for the changes to take effect. Click the OK button to restart Windows. The STB Vision group is created in the Program Manager.
If our documentation hasn't helped you,
this might be a good time to send
an e-mail to Technical Support.
Copyright © 1996 Gateway 2000 Inc. All rights reserved.
Please see our Legal Information. Please send feedback to Webmaster Central.